HAIMA 7 - Page 43

Technique parameters
7
Technical specification of service
Items Parameters
Compression pressure
kpa{kgf/cm
2
,psi}[rpm]}
Standard value 1370{14.0, 199}[300]
Minimum limit 1080{11.0, 156}[300]
Maximum limit of pressure
difference among cylinders
200{2.0, 28}
Engine oil pressure (kpa{kfg/cm
2
, psi}[rpm])
446～588{4.6～6.1, 64～
84}[2500]
Engine oil filling
amount L{US qt,lmp qt}
Replacement of engine oil 3.1{3.2, 2.7}
Replacement of engine oil and
engine oil filter
3.3{3.5, 2.9}
Engine oil grade API engine oil grade SJ or above
Engine oil viscosity
grade
Above –25 ℃{13℉} SAE 10W–30
-30 ℃-37 ℃{-22 ℉-98 ℉} SAE 5W–30
Alternator belt
Deflection (mm{in})
[With a 98N
{10kgf,22lbf} force
applied in the middle]
New 6.5～7.5{0.26～0.29}
Old 7.0～9.0{0.28～0.35}
Limit 10{0.39}
Tension force
N{kgf,lbf}
New 686～834{70～85, 160～180}
Old 490～686{50～70, 120～150}
Limit 392{40, 88}
Starter
Unloaded test
Voltage (V) 14
Current (A) 110
Assembly/disassembly part of timing chain
Extension length of automatic tensioner push rod (mm{in}) 3{0.1181}
Crankshaft speed sensor
Gap between signal wheel and sensor (mm{in}) 0.5～1.1{0.020～0.043}
Thermostat
Open temperature (ºC{°F}) 80～84{176～183}
Full open temperature (ºC{°F}) 95{203}
Full open travel (mm{in}) ≥8.5{0.33}
Clutch pressure plate
Diaphragm spring
Depth (mm{in}) ≤0.6{0.024}
Radial run-out (mm{in}) ≤0.6{0.024}
Flatness of pressure plate (mm{in}) 0.05{0.0019}
Clutch friction plate