Floor covering
S-51
7. Remove the snap F.
8. Remove the handle trim cap H;
9. Remove the screws G (two pcs).
10. Remove the switch panel J;
11. Disconnect the connection between the PW
main switch and auxiliary switch plug (only
driver-side)
12. To loosen 8 snaps M, you need to insert your
hand into the slot of switch panel and pull
outward the panel so as to disengage the
locking pin from the hole of sheet metal;
13. To dismount the door lamp, rotate
counterclockwise the bulb holder so as to
disengage it from the hole of door panel.
14. Pull upward the trim panel of front door so as
to disengage the upper edge curls of door panel
from the sheet metal.
To Next Page
Loading...