Wiper and washer
T-21
Steps Check Display Measures
4
Open occupant-side
rear door (Door switch
On)
After closing the occupant-side rear door, go to the
next step.
Measure the voltage of combination instrument
terminal 1L.
Is the voltage equal to 0V？
l If this value is satisfied, replace the combination
instrument.
l If this value is unsatisfied, check the following
parts.
— Door switch
— Harness(combination instrument—door
switch)
5
Open lift gate (Trunk
light switch On)
Close the lift gate and then go to the next step.
Measure the voltage of combination instrument
terminal 1I.
Is the voltage equal to 0V？
l If this value is satisfied, replace the combination
instrument;
l If this value is unsatisfied, check the following
parts.
— Door switch
— Harness(combination instrument—door
switch)
6
Close all doors and lift
gate (Door and trunk
light switches Off)
Measure the voltage of combination instrument
terminal 1L.
Is the voltage equal to B+？
l If this value is satisfied, replace the combination
instrument;
l If this value is unsatisfied, check the following
parts.
— Door switch
— Harness(combination instrument—door
switch)
The signal input of combination instrument is
normal.
DTC 05 Switch signal On/Off of door lock linkage
Combination instrument connectors
Harness side connector
(Viewed from the harness side)
XMET18W017
To Next Page
Loading...