HAIMA 7 - Page 88

Cylinder head and valve mechanisms
52
(Intake: 0.22mm{0.0087in}; exhaust: 0.30mm{0.0118in})
5. Contain the selected tappet into the tappet hole.
6. Reconfirm the valve clearance (See the Valve Clearance, Inspection of Valve Clearance).
Attention
l The thickness of tappet will be marked in 3 digitals at the side of tappet as
shown in Fig., below.
Relationship between the tappet mark and thickness is shown in the following table:
Mark Thickness (mm) Mark Thickness (mm) Mark Thickness (mm)
270 2.70 292 2.92 314 3.14
272 2.72 294 2.94 316 3.16
274 2.74 296 2.96 318 3.18
276 2.76 298 2.98 320 3.20
278 2.78 300 3.00 322 3.22
280 2.80 302 3.02 324 3.24
282 2.82 304 3.04 326 3.26
284 2.84 306 3.06 328 3.28
286 2.86 308 3.08 330 3.30
288 2.88 310 3.10
290 2.90 312 3.12
Thickness mark