:SEARch Commands 30
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1021
:SEARch:TRANsition:SLOPe
(see page 1428)
Command Syntax
:SEARch:TRANsition:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :SEARch:TRANsition:SLOPe command selects whether to search for rising
edge (POSitive slope) transitions or falling edge (NEGative slope) transitions.
Query Syntax
:SEARch:TRANsition:SLOPe?
The :SEARch:TRANsition:SLOPe? query returns the current transition search slope
setting.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also • Chapter 30, “:SEARch Commands,” starting on page 993
• ":SEARch:MODE" on page 997
• ":SEARch:TRANsition:SOURce" on page 1022
• ":SEARch:TRANsition:TIME" on page 1023
To Next Page
Loading...
