:SEARch Commands 30
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 997
:SEARch:MODE
(see page 1428)
Command Syntax
:SEARch:MODE <value>
<value> ::= {EDGE | GLITch | RUNT | TRANsition | SERial{1 | 2} | PEAK}
The :SEARch:MODE command selects the search mode.
The command is only valid when the :SEARch:STATe is ON.
Query Syntax
:SEARch:MODE?
The :SEARch:MODE? query returns the currently selected mode or OFF if the
:SEARch:STATe is OFF.
Return Format
<value><NL>
<value> ::= {EDGE | GLIT | RUNT | TRAN | SER{1 | 2} | PEAK | OFF}
See Also • Chapter 30, “:SEARch Commands,” starting on page 993
• ":SEARch:STATe" on page 998
• ":SEARch:COUNt" on page 995
• ":SEARch:EVENt" on page 996
To Next Page
Loading...
