368 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
15 :DISPlay Commands
:DISPlay:CLEar
(see page 1428)
Command Syntax
:DISPlay:CLEar
The :DISPlay:CLEar command clears the display and resets all associated
measurements. If the oscilloscope is stopped, all currently displayed data is
erased. If the oscilloscope is running, all of the data for active channels and
functions is erased; however, new data is displayed on the next acquisition.
See Also • "Introduction to :DISPlay Commands" on page 360
To Next Page
Loading...
