Common (*) Commands 6
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 233
*CLS (Clear Status)
(see page 1610)
Command Syntax
*CLS
The *CLS common command clears the status data structures, the device-defined
error queue, and the Request-for-OPC flag.
See Also • "Introduction to Common (*) Commands" on page 231
• "*STB (Read Status Byte)" on page 250
• "*ESE (Standard Event Status Enable)" on page 234
• "*ESR (Standard Event Status Register)" on page 236
• "*SRE (Service Request Enable)" on page 248
• ":SYSTem:ERRor" on page 1264
If the *CLS command immediately follows a program message terminator, the output queue
and the MAV (message available) bit are cleared.
To Next Page
Loading...
Need help?
General
