:TRIGger Commands 33
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1205
:TRIGger:SHOLd:SLOPe
(see page 1428)
Command Syntax
:TRIGger:SHOLd:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :TRIGger:SHOLd:SLOPe command specifies whether the rising edge or the
falling edge of the clock signal is used.
Query Syntax
:TRIGger:SHOLd:SLOPe?
The :TRIGger:SHOLd:SLOPe? query returns the current rising or falling edge
setting.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also • "Introduction to :TRIGger Commands" on page 1139
• ":TRIGger:MODE" on page 1148
• ":TRIGger:SHOLd:SOURce:CLOCk" on page 1206
• ":TRIGger:SHOLd:SOURce:DATA" on page 1207
To Next Page
Loading...
