1038 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
30 :SEARch Commands
:SEARch:SERial:CAN:SYMBolic:SIGNal
(see page 1428)
Command Syntax
:SEARch:SERial:CAN:SYMBolic:SIGNal <name>
<name> ::= quoted ASCII string
The :SEARch:SERial:CAN:SYMBolic:SIGNal command specifies the signal to
search for when CAN symbolic data has been loaded (recalled) into the
oscilloscope and the CAN serial search mode is set to MSIGnal.
Query Syntax
:SEARch:SERial:CAN:SYMBolic:SIGNal?
The :SEARch:SERial:CAN:SYMBolic:SIGNal? query returns the specified signal.
Return Format
<name><NL>
<name> ::= quoted ASCII string
See Also • ":RECall:DBC[:STARt]" on page 716
• ":SEARch:SERial:CAN:MODE" on page 1031
• ":SEARch:SERial:CAN:SYMBolic:MESSage" on page 1037
• ":SEARch:SERial:CAN:SYMBolic:VALue" on page 1039
To Next Page
Loading...
