:POWer Commands 26
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 661
:POWer:ONOFf:APPLy
(see page 1428)
Command Syntax
:POWer:ONOFf:APPLy
The :POWer:ONOFf:APPLy command applies the selected turn on/off analysis test
(:POWer:ONOFf:TEST).
See Also • ":POWer:SIGNals:VSTeady:ONOFf:OFF" on page 695
• ":POWer:SIGNals:VSTeady:ONOFf:ON" on page 696
• ":POWer:ITYPe" on page 657
• ":POWer:ONOFf:THResholds" on page 665
• ":POWer:ONOFf:TEST" on page 664
• ":POWer:ONOFf:EXIT" on page 662
• ":POWer:ONOFf:NEXT" on page 663
• ":MEASure:ONTime" on page 568
• ":MEASure:OFFTime" on page 567
To Next Page
Loading...
