Keysight Technologies InfiniiVision MSO-X 4022A

:SBUS<n> Commands 29
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 957
:SBUS<n>:UART:PARity
(see page 1428)
Command Syntax
:SBUS<n>:UART:PARity <parity>
<parity> ::= {EVEN | ODD | NONE}
The :SBUS<n>:UART:PARity command selects the parity to be used with each
message "byte" for the serial decoder and/or trigger when in UART mode.
Query Syntax
:SBUS<n>:UART:PARity?
The :SBUS<n>:UART:PARity? query returns the current UART parity setting.
Return Format
<parity><NL>
<parity> ::= {EVEN | ODD | NONE}
See Also • "Introduction to :TRIGger Commands" on page 1139
• ":TRIGger:MODE" on page 1148
• ":SBUS<n>:UART:TRIGger:TYPE" on page 966