804 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
29 :SBUS<n> Commands
:SBUS<n>:CAN:TRIGger:SYMBolic:MESSage
(see page 1428)
Command Syntax
:SBUS<n>:CAN:TRIGger:SYMBolic:MESSage <name>
<name> ::= quoted ASCII string
The :SBUS<n>:CAN:TRIGger:SYMBolic:MESSage command specifies the message
to trigger on when CAN symbolic data has been loaded (recalled) into the
oscilloscope and the CAN trigger mode is set to MESSage or MSIGnal.
Query Syntax
:SBUS<n>:CAN:TRIGger:SYMBolic:MESSage?
The :SBUS<n>:CAN:TRIGger:SYMBolic:MESSage? query returns the specified
message.
Return Format
<name><NL>
<name> ::= quoted ASCII string
See Also • ":RECall:DBC[:STARt]" on page 716
• ":SBUS<n>:CAN:TRIGger" on page 794
• ":SBUS<n>:CAN:TRIGger:SYMBolic:SIGNal" on page 805
• ":SBUS<n>:CAN:TRIGger:SYMBolic:VALue" on page 806
To Next Page
Loading...
