1188 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
33 :TRIGger Commands
:TRIGger:NFC:TIMeout:TIME
(see page 1428)
Command Syntax
:TRIGger:NFC:TIMeout:TIME <time>
<time> ::= seconds in NR3 format
The :TRIGger:NFC:TIMeout:TIME command specifies the timeout period. With the
ATRigger (Arm & Trigger) trigger event, if the second event does not occur within
the timeout period, the oscilloscope triggers when the timeout period expires.
Query Syntax
:TRIGger:NFC:TIMeout:TIME?
The :TRIGger:NFC:TIMeout:TIME? query returns the specified timeout period.
Return Format
<time><NL>
<time> ::= seconds in NR3 format
See Also • ":TRIGger:NFC:AEVent" on page 1180
• ":TRIGger:NFC:ATTime" on page 1181
• ":TRIGger:NFC:SOURce" on page 1182
• ":TRIGger:NFC:STANdard" on page 1183
• ":TRIGger:NFC:TEVent" on page 1184
• ":TRIGger:NFC:TIMeout" on page 1186
• ":TRIGger:NFC:TIMeout:ENABle" on page 1187
To Next Page
Loading...
