Keysight Technologies InfiniiVision MSO-X 4022A

908 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
29 :SBUS<n> Commands
:SBUS<n>:SENT:PPULse
(see page 1428)
Command Syntax
:SBUS<n>:SENT:PPULse {{0 | OFF} | {1 | ON}}
The :SBUS<n>:SENT:PPULse command specifies whether the SENT messages are
followed by a pause pulse.
Query Syntax
:SBUS<n>:SENT:PPULse?
The :SBUS<n>:SENT:PPULse? query returns the pause pulse setting.
Return Format
<setting><NL>
<setting> ::= {0 | 1}
See Also • ":SBUS<n>:SENT:CLOCk" on page 900
• ":SBUS<n>:SENT:CRC" on page 901
• ":SBUS<n>:SENT:DISPlay" on page 902
• ":SBUS<n>:SENT:FORMat" on page 904
• ":SBUS<n>:SENT:IDLE" on page 906
• ":SBUS<n>:SENT:LENGth" on page 907
• ":SBUS<n>:SENT:SIGNal<s>:DISPlay" on page 909
• ":SBUS<n>:SENT:SIGNal<s>:LENGth" on page 910
• ":SBUS<n>:SENT:SIGNal<s>:MULTiplier" on page 912
• ":SBUS<n>:SENT:SIGNal<s>:OFFSet" on page 913
• ":SBUS<n>:SENT:SIGNal<s>:ORDer" on page 914
• ":SBUS<n>:SENT:SIGNal<s>:STARt" on page 916
• ":SBUS<n>:SENT:SOURce" on page 918
• ":SBUS<n>:SENT:TOLerance" on page 920
• ":SBUS<n>:SENT:TRIGger" on page 921
• ":SBUS<n>:SENT:TRIGger:FAST:DATA" on page 923
• ":SBUS<n>:SENT:TRIGger:SLOW:DATA" on page 924
• ":SBUS<n>:SENT:TRIGger:SLOW:ID" on page 926
• ":SBUS<n>:SENT:TRIGger:SLOW:ILENgth" on page 928
• ":SBUS<n>:SENT:TRIGger:TOLerance" on page 929