508 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
21 :HARDcopy/:HCOPY Commands
:HARDcopy:FACTors
(see page 1610)
Command Syntax
:HARDcopy:FACTors <factors>
<factors> ::= {{OFF | 0} | {ON | 1}}
The HARDcopy:FACTors command controls whether the scale factors are output
on the hardcopy dump.
Query Syntax
:HARDcopy:FACTors?
The :HARDcopy:FACTors? query returns a flag indicating whether oscilloscope
instrument settings are output on the hardcopy.
Return Format
<factors><NL>
<factors> ::= {0 | 1}
See Also • "Introduction to :HARDcopy Commands" on page 504
• ":HARDcopy:STARt" on page 520
• ":HARDcopy:FFEed" on page 509
• ":HARDcopy:INKSaver" on page 510
• ":HARDcopy:LAYout" on page 511
• ":HARDcopy:PALette" on page 518
To Next Page
Loading...
Need help?
General
