672 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
26 :POWer Commands
:POWer:PSRR:FREQuency:MODE
(see page 1428)
Command Syntax
:POWer:PSRR:FREQuency:MODE <mode>
<mode> ::= {SWEep | SINGle}
The :POWer:PSRR:FREQuency:MODE command specifies whether the analysis
should be performed by sweeping through a range of frequencies (SWEep) or at a
single frequency (SINGle).
The SINGle mode is useful for evaluating amplitudes at a single frequency. After
running the test at a single frequency, you can manually adjust (increase) the
waveform generator's amplitude until you begin to observe distortion in the
waveforms on the oscilloscope's display. You can then use that amplitude at all
frequencies in SWEep mode, or you can evaluate amplitudes at other frequencies
in order to determine an optimized amplitude profile (see
:POWer:PSRR:WGEN:VOLTage:PROFile).
Query Syntax
:POWer:CLResponse:FREQuency:MODE?
The :POWer:PSRR:FREQuency:MODE? query returns the frequency mode setting.
Return Format
<mode><NL>
<mode> ::= {SWE | SING}
See Also • ":POWer:PSRR" on page 667
• ":POWer:PSRR:APPLy" on page 668
• ":POWer:PSRR:DATA" on page 669
• ":POWer:PSRR:FREQuency:MAXimum" on page 670
• ":POWer:PSRR:FREQuency:MINimum" on page 671
• ":POWer:PSRR:PPDecade" on page 673
• ":POWer:PSRR:SOURce:INPut" on page 674
• ":POWer:PSRR:SOURce:OUTPut" on page 675
• ":POWer:PSRR:WGEN:LOAD" on page 676
• ":POWer:PSRR:WGEN:VOLTage" on page 677
• ":POWer:PSRR:WGEN:VOLTage:PROFile" on page 678
To Next Page
Loading...
