:SBUS<n> Commands 29
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 953
:SBUS<n>:UART:COUNt:RESet
(see page 1428)
Command Syntax
:SBUS<n>:UART:COUNt:RESet
Resets the UART frame counters.
Errors • "-241, Hardware missing" on page 1387
See Also • ":SBUS<n>:UART:COUNt:ERRor" on page 952
• ":SBUS<n>:UART:COUNt:RXFRames" on page 954
• ":SBUS<n>:UART:COUNt:TXFRames" on page 955
• "Introduction to :SBUS<n> Commands" on page 755
• ":SBUS<n>:MODE" on page 759
• ":SBUS<n>:UART Commands" on page 946
To Next Page
Loading...
