:SAVE Commands 28
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 753
:SAVE:WMEMory[:STARt]
(see page 1428)
Command Syntax
:SAVE:WMEMory[:STARt] [<file_name>]
<file_name> ::= quoted ASCII string
The :SAVE:WMEMory[:STARt] command saves oscilloscope waveform data to a
reference waveform file.
See Also • "Introduction to :SAVE Commands" on page 725
• ":SAVE:WMEMory:SOURce" on page 752
• ":RECall:WMEMory<r>[:STARt]" on page 722
If a file extension is provided as part of a specified <file_name>, it must be ".h5".
To Next Page
Loading...
