830 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
29 :SBUS<n> Commands
:SBUS<n>:FLEXray:COUNt:RESet
(see page 1428)
Command Syntax
:SBUS<n>:FLEXray:COUNt:RESet
Resets the FlexRay frame counters.
Errors • "-241, Hardware missing" on page 1387
See Also • ":SBUS<n>:FLEXray:COUNt:NULL" on page 829
• ":SBUS<n>:FLEXray:COUNt:TOTal" on page 832
• ":SBUS<n>:FLEXray:COUNt:SYNC" on page 831
• "Introduction to :SBUS<n> Commands" on page 755
• ":SBUS<n>:MODE" on page 759
• ":SBUS<n>:FLEXray Commands" on page 824
To Next Page
Loading...
