:SBUS<n> Commands 29
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 805
:SBUS<n>:CAN:TRIGger:SYMBolic:SIGNal
(see page 1428)
Command Syntax
:SBUS<n>:CAN:TRIGger:SYMBolic:SIGNal <name>
<name> ::= quoted ASCII string
The :SBUS<n>:CAN:TRIGger:SYMBolic:SIGNal command specifies the signal to
trigger on when CAN symbolic data has been loaded (recalled) into the
oscilloscope and the CAN trigger mode is set to MSIGnal.
Query Syntax
:SBUS<n>:CAN:TRIGger:SYMBolic:SIGNal?
The :SBUS<n>:CAN:TRIGger:SYMBolic:SIGNal? query returns the specified signal.
Return Format
<name><NL>
<name> ::= quoted ASCII string
See Also • ":RECall:DBC[:STARt]" on page 716
• ":SBUS<n>:CAN:TRIGger" on page 794
• ":SBUS<n>:CAN:TRIGger:SYMBolic:MESSage" on page 804
• ":SBUS<n>:CAN:TRIGger:SYMBolic:VALue" on page 806
To Next Page
Loading...
