:BUS<n> Commands 8
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 285
:BUS<n>:DISPlay
(see page 1428)
Command Syntax
:BUS<n>:DISplay <value>
<value> ::= {{1 | ON} | {0 | OFF}}
<n> ::= An integer, 1 or 2, is attached as a suffix to BUS
and defines the bus that is affected by the command.
The :BUS<n>:DISPlay command enables or disables the view of the selected bus.
Query Syntax
:BUS<n>:DISPlay?
The :BUS<n>:DISPlay? query returns the display value of the selected bus.
Return Format
<value><NL>
<value> ::= {0 | 1}
See Also • "Introduction to :BUS<n> Commands" on page 280
• ":BUS<n>:BIT<m>" on page 281
• ":BUS<n>:BITS" on page 282
• ":BUS<n>:CLEar" on page 284
• ":BUS<n>:LABel" on page 286
• ":BUS<n>:MASK" on page 287
This command is only valid for the MSO models.
To Next Page
Loading...
