Keysight Technologies InfiniiVision MSO-X 4022A

:SBUS<n> Commands 29
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 935
:SBUS<n>:SPI:FRAMing
(see page 1428)
Command Syntax
:SBUS<n>:SPI:FRAMing <value>
<value> ::= {CHIPselect | {NCHipselect | NOTC} | TIMeout}
The :SBUS<n>:SPI:FRAMing command sets the SPI trigger framing value. If
TIMeout is selected, the timeout value is set by the :SBUS<n>:SPI:CLOCk:TIMeout
command.
Query Syntax
:SBUS<n>:SPI:FRAMing?
The :SBUS<n>:SPI:FRAMing? query returns the current SPI framing value.
Return Format
<value><NL>
<value> ::= {CHIP | NCH | TIM}
See Also • "Introduction to :TRIGger Commands" on page 1139
• ":TRIGger:MODE" on page 1148
• ":SBUS<n>:SPI:CLOCk:TIMeout" on page 934
• ":SBUS<n>:SPI:SOURce:FRAMe" on page 937
NOTE
The NOTC value is deprecated. It is the same as NCHipselect.