Obsolete and Discontinued Commands 37
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1373
:MTESt:{STARt | STOP}
(see page 1428)
Command Syntax
:MTESt:{STARt | STOP}
The :MTESt:{STARt | STOP} command starts or stops the acquisition system.
See Also • "Introduction to :MTESt Commands" on page 581
The :MTESt:STARt and :MTESt:STOP commands are obsolete and are provided for backward
compatibility to previous oscilloscopes. Use the :RUN command (see page 256) and :STOP
command (see page 260) instead.
To Next Page
Loading...
