590 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
24 :MTESt Commands
:MTESt:COUNt:FWAVeforms
(see page 1428)
Query Syntax
:MTESt:COUNt:FWAVeforms? [CHANnel<n>]
<n> ::= 1 to (# analog channels) in NR1 format
The :MTESt:COUNt:FWAVeforms? query returns the total number of failed
waveforms in the current mask test run. This count is for all regions and all
waveforms collected on the channel specified by the optional parameter or
collected on the currently specified source channel (:MTESt:SOURce) if there is no
parameter.
Return Format
<failed><NL>
<failed> ::= number of failed waveforms in NR1 format.
See Also • "Introduction to :MTESt Commands" on page 581
• ":MTESt:COUNt:WAVeforms" on page 593
• ":MTESt:COUNt:TIME" on page 592
• ":MTESt:COUNt:RESet" on page 591
• ":MTESt:SOURce" on page 611
Example Code • "Example Code" on page 581
To Next Page
Loading...
