Keysight Technologies InfiniiVision MSO-X 4022A

:POWer Commands 26
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 677
:POWer:PSRR:WGEN:VOLTage
(see page 1428)
Command Syntax
:POWer:PSRR:WGEN:VOLTage <amplitude>[,<range>]
<amplitude> ::= amplitude in volts in NR3 format
<range> ::= {F20HZ | F100HZ | F1KHZ | F10KHZ | F100KHZ | F1MHZ
| F10MHZ | F20MHZ}
The :POWer:PSRR:WGEN:VOLTage command sets the waveform generator output
amplitude(s).
When the waveform generator amplitude profile is enabled (with the
:POWer:PSRR:WGEN:VOLTage:PROFile command), you can set an initial ramp
amplitude for each frequency range.
Without the <range> parameter, this command sets the waveform generator
output amplitude used when the amplitude profile is disabled.
Query Syntax
:POWer:PSRR:WGEN:VOLTage? [<range>]
The :POWer:PSRR:WGEN:VOLTage? query returns the waveform generator output
amplitude setting(s).
Return Format
<amplitude><NL>
<amplitude> ::= amplitude in volts in NR3 format
See Also • ":POWer:PSRR" on page 667
• ":POWer:PSRR:APPLy" on page 668
• ":POWer:PSRR:DATA" on page 669
• ":POWer:PSRR:FREQuency:MAXimum" on page 670
• ":POWer:PSRR:FREQuency:MINimum" on page 671
• ":POWer:PSRR:FREQuency:MODE" on page 672
• ":POWer:PSRR:PPDecade" on page 673
• ":POWer:PSRR:SOURce:INPut" on page 674
• ":POWer:PSRR:SOURce:OUTPut" on page 675
• ":POWer:PSRR:WGEN:LOAD" on page 676
• ":POWer:PSRR:WGEN:VOLTage:PROFile" on page 678