:SBUS<n> Commands 29
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 793
:SBUS<n>:CAN:SOURce
(see page 1428)
Command Syntax
:SBUS<n>:CAN:SOURce <source>
<source> ::= {CHANnel<n> | EXTernal} for the DSO models
<source> ::= {CHANnel<n> | DIGital<d>} for the MSO models
<n> ::= 1 to (# analog channels) in NR1 format
<d> ::= 0 to (# digital channels - 1) in NR1 format
The :SBUS<n>:CAN:SOURce command sets the source for the CAN signal.
Query Syntax
:SBUS<n>:CAN:SOURce?
The :SBUS<n>:CAN:SOURce? query returns the current source for the CAN signal.
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 1139
• ":SBUS<n>:MODE" on page 759
• ":SBUS<n>:CAN:TRIGger" on page 794
• ":SBUS<n>:CAN:SIGNal:DEFinition" on page 791
To Next Page
Loading...
