:SBUS<n> Commands 31
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 895
CAN Id specification is set by the :SBUS<n>:CAN:TRIGger:PATTern:ID
and:SBUS<n>:CAN:TRIGger:PATTern:ID:MODE commands.
CAN Data specification is set by the :SBUS<n>:CAN:TRIGger:PATTern:DATA
command.
CAN Data Length Code is set by the
:SBUS<n>:CAN:TRIGger:PATTern:DATA:LENGth command.
Query Syntax
:SBUS<n>:CAN:TRIGger?
The :SBUS<n>:CAN:TRIGger? query returns the current CAN trigger on condition.
Return Format
<condition><NL>
<condition> ::= {SOF | EOF | IDD | DATA | FDD | IDR | IDE | ERR | ACK
| FORM | STUF | CRC | SPEC | ALL | BRSB | CRCD | EBA | EBP | OVER
| MESS | MSIG | FDMS}
Errors • "-241, Hardware missing" on page 1551
See Also • "Introduction to :SBUS<n> Commands" on page 853
CRCerror CRC Field Error Triggers when the calculated CRC does not
match the transmitted CRC. In addition, for
FD frames, will also trigger if the Stuff
Count is in error.
X
SPECerror Spec Error (Ack or Form
or Stuff or CRC)
Triggers on Ack, Form, Stuff, or CRC errors. X
ALLerrors All Errors Triggers on all Spec errors and error frames. X
BRSBit BRS Bit (FD) Triggers on the BRS bit of CAN FD frames. X
CRCDbit CRC Delimiter Bit (FD) Triggers on the CRC delimiter bit in CAN FD
frames.
X
EBActive ESI Bit Active (FD) Triggers on the ESI bit if set active. X
EBPassive ESI Bit Passive (FD) Triggers on the ESI bit if set passive. X
OVERload Overload Frame Triggers on an overload frame.
MESSage Message Triggers on a symbolic message.
MSIGnal Message and Signal
(non-FD)
Triggers on a symbolic message and a
signal value.
FDMSignal Message and Signal (FD,
first 8 bytes only)
Triggers on a symbolic message and a
signal value, limited to the first 8 bytes of
FD data.
* Filtering by CAN IDs is available for these trigger conditions (see :SBUS<n>:CAN:TRIGger:IDFilter).
Condition Front-panel name Description Filter by
ID*
To Next Page
Loading...
Need help?
General
