:HARDcopy Commands 19
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 433
:HARDcopy:FACTors
(see page 1428)
Command Syntax
:HARDcopy:FACTors <factors>
<factors> ::= {{OFF | 0} | {ON | 1}}
The HARDcopy:FACTors command controls whether the scale factors are output
on the hardcopy dump.
Query Syntax
:HARDcopy:FACTors?
The :HARDcopy:FACTors? query returns a flag indicating whether oscilloscope
instrument settings are output on the hardcopy.
Return Format
<factors><NL>
<factors> ::= {0 | 1}
See Also • "Introduction to :HARDcopy Commands" on page 430
• ":HARDcopy:STARt" on page 445
• ":HARDcopy:FFEed" on page 434
• ":HARDcopy:INKSaver" on page 435
• ":HARDcopy:LAYout" on page 436
• ":HARDcopy:PALette" on page 443
To Next Page
Loading...
