354 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
14 :DIGital<d> Commands
:DIGital<d>:LABel
(see page 1428)
Command Syntax
:DIGital<d>:LABel <string>
<d> ::= 0 to (# digital channels - 1) in NR1 format
<string> ::= any series of 10 or less characters as quoted ASCII string.
The :DIGital<d>:LABel command sets the channel label to the string that follows.
Setting a label for a channel also adds the name to the label list in non-volatile
memory (replacing the oldest label in the list).
Query Syntax
:DIGital<d>:LABel?
The :DIGital<d>:LABel? query returns the name of the specified channel.
Return Format
<label string><NL>
<label string> ::= any series of 10 or less characters as a quoted
ASCII string.
See Also • "Introduction to :DIGital<d> Commands" on page 352
• ":CHANnel<n>:LABel" on page 309
• ":DISPlay:LABList" on page 372
• ":BUS<n>:LABel" on page 286
This command is only valid for the MSO models.
Label strings are 10 characters or less, and may contain any commonly used ASCII characters.
Labels with more than 10 characters are truncated to 10 characters.
To Next Page
Loading...
