Keysight Technologies InfiniiVision MSO-X 4022A

:POWer Commands 26
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 681
:POWer:SIGNals:AUTosetup
(see page 1428)
Command Syntax
:POWer:SIGNals:AUTosetup <analysis>
<analysis> ::= {HARMonics | EFFiciency | RIPPle | MODulation | QUALity
| SLEW | SWITch | RDSVce}
The :POWer:SIGNals:AUTosetup command performs automated oscilloscope
setup for the signals in the specified type of power analysis.
See Also • ":POWer:HARMonics:DISPlay" on page 644
• ":POWer:EFFiciency:APPLy" on page 639
• ":POWer:RIPPle:APPLy" on page 680
• ":POWer:MODulation:APPLy" on page 658
• ":POWer:QUALity:APPLy" on page 679
• ":POWer:SLEW:APPLy" on page 700
• ":POWer:SWITch:APPLy" on page 702
• ":POWer:SIGNals:CYCLes:HARMonics" on page 682
• ":POWer:SIGNals:CYCLes:QUALity" on page 683
• ":POWer:SIGNals:DURation:EFFiciency" on page 684
• ":POWer:SIGNals:DURation:MODulation" on page 685
• ":POWer:SIGNals:DURation:RIPPle" on page 688
• ":POWer:SIGNals:IEXPected" on page 690
• ":POWer:SIGNals:OVERshoot" on page 691
• ":POWer:SIGNals:SOURce:CURRent<i>" on page 698
• ":POWer:SIGNals:SOURce:VOLTage<i>" on page 699