Common (*) Commands 5
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 201
*CLS (Clear Status)
(see page 1428)
Command Syntax
*CLS
The *CLS common command clears the status data structures, the device-defined
error queue, and the Request-for-OPC flag.
See Also • "Introduction to Common (*) Commands" on page 200
• "*STB (Read Status Byte)" on page 218
• "*ESE (Standard Event Status Enable)" on page 202
• "*ESR (Standard Event Status Register)" on page 204
• "*SRE (Service Request Enable)" on page 216
• ":SYSTem:ERRor" on page 1107
If the *CLS command immediately follows a program message terminator, the output queue
and the MAV (message available) bit are cleared.
To Next Page
Loading...
