662 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
26 :POWer Commands
:POWer:ONOFf:EXIT
(see page 1428)
Command Syntax
:POWer:ONOFf:EXIT
The :POWer:ONOFf:EXIT command exits (stops) the turn on time/turn off time
analysis.
This command is equivalent to pressing the Exit softkey on the oscilloscope front
panel during the analysis.
See Also • ":POWer:ONOFf:THResholds" on page 665
• ":POWer:ITYPe" on page 657
• ":POWer:ONOFf:APPLy" on page 661
• ":POWer:ONOFf:NEXT" on page 663
• ":POWer:ONOFf:TEST" on page 664
To Next Page
Loading...
