:SAVE Commands 28
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 737
:SAVE:MULTi[:STARt]
(see page 1428)
Command Syntax
:SAVE:MULTi[:STARt] [<file_name>]
<file_name> ::= quoted ASCII string
The :SAVE:MULTi[:STARt] command saves multi-channel waveform data to a file.
This file can be opened by the N8900A Infiniium Offline oscilloscope analysis
software.
See Also • "Introduction to :SAVE Commands" on page 725
• ":SAVE:FILename" on page 729
• ":SAVE:PWD" on page 739
If a file extension is provided as part of a specified <file_name>, it must be ".h5".
To Next Page
Loading...
