Keysight Technologies InfiniiVision MSO-X 4022A

718 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
27 :RECall Commands
:RECall:LDF[:STARt]
(see page 1428)
Command Syntax
:RECall:LDF[:STARt] [<file_name>] [, <serialbus>]
<file_name> ::= quoted ASCII string
<serialbus> ::= {SBUS<n>}
<n> ::= 1 to (# of serial bus) in NR1 format
The :RECall:LDF[:STARt] command loads a LIN description file (LDF) symbolic data
file into the oscilloscope.
The <serialbus> parameter specifies which serial decode waveform the LIN
symbolic data will be loaded for.
See Also • "Introduction to :RECall Commands" on page 714
• ":RECall:FILename" on page 717
• ":SBUS<n>:LIN:TRIGger" on page 881
• ":SBUS<n>:LIN:TRIGger:SYMBolic:FRAMe" on page 887
• ":SBUS<n>:LIN:TRIGger:SYMBolic:SIGNal" on page 888
• ":SBUS<n>:LIN:TRIGger:SYMBolic:VALue" on page 889
• ":SEARch:SERial:LIN:MODE" on page 1061
• ":SEARch:SERial:LIN:SYMBolic:FRAMe" on page 1065
• ":SEARch:SERial:LIN:SYMBolic:SIGNal" on page 1066
• ":SEARch:SERial:LIN:SYMBolic:VALue" on page 1067
NOTE
If a file extension is provided as part of a specified <file_name>, it must be ".ldf".