:HARDcopy Commands 19
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 445
:HARDcopy:STARt
(see page 1428)
Command Syntax
:HARDcopy:STARt
The :HARDcopy:STARt command starts a print job.
See Also • "Introduction to :HARDcopy Commands" on page 430
• ":HARDcopy:APRinter" on page 432
• ":HARDcopy:PRINter:LIST" on page 444
• ":HARDcopy:FACTors" on page 433
• ":HARDcopy:FFEed" on page 434
• ":HARDcopy:INKSaver" on page 435
• ":HARDcopy:LAYout" on page 436
• ":HARDcopy:PALette" on page 443
To Next Page
Loading...
