:SBUS<n> Commands 29
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 949
:SBUS<n>:UART:BASE
(see page 1428)
Command Syntax
:SBUS<n>:UART:BASE <base>
<base> ::= {ASCii | BINary | HEX}
The :SBUS<n>:UART:BASE command determines the base to use for the UART
decode and Lister display.
Query Syntax
:SBUS<n>:UART:BASE?
The :SBUS<n>:UART:BASE? query returns the current UART decode and Lister
base setting.
Return Format
<base><NL>
<base> ::= {ASCii | BINary | HEX}
Errors • "-241, Hardware missing" on page 1387
See Also • "Introduction to :SBUS<n> Commands" on page 755
• ":SBUS<n>:UART Commands" on page 946
To Next Page
Loading...
