Keysight Technologies InfiniiVision MSO-X 4022A

716 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
27 :RECall Commands
:RECall:DBC[:STARt]
(see page 1428)
Command Syntax
:RECall:DBC[:STARt] [<file_name>] [, <serialbus>]
<file_name> ::= quoted ASCII string
<serialbus> ::= {SBUS<n>}
<n> ::= 1 to (# of serial bus) in NR1 format
The :RECall:DBC[:STARt] command loads a CAN DBC (communication database)
symbolic data file into the oscilloscope.
The <serialbus> parameter specifies which serial decode waveform the CAN
symbolic data will be loaded for.
See Also • "Introduction to :RECall Commands" on page 714
• ":RECall:FILename" on page 717
• ":SBUS<n>:CAN:TRIGger" on page 794
• ":SBUS<n>:CAN:TRIGger:SYMBolic:MESSage" on page 804
• ":SBUS<n>:CAN:TRIGger:SYMBolic:SIGNal" on page 805
• ":SBUS<n>:CAN:TRIGger:SYMBolic:VALue" on page 806
• ":SEARch:SERial:CAN:MODE" on page 1031
• ":SEARch:SERial:CAN:SYMBolic:MESSage" on page 1037
• ":SEARch:SERial:CAN:SYMBolic:SIGNal" on page 1038
• ":SEARch:SERial:CAN:SYMBolic:VALue" on page 1039
NOTE
If a file extension is provided as part of a specified <file_name>, it must be ".dbc".