:WGEN<w> Commands 35
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1311
:WGEN<w>:TRACk:FREQuency
(see page 1428)
Command Syntax
:WGEN<w>:TRACk:FREQuency <on_off>
<w> ::= 1 or 2 in NR1 format
<on_off> ::= {{1 | ON} | {0 | OFF}
The :WGEN<w>:TRACk:FREQuency ON command causes frequency adjustments
to this waveform generator output signal to be tracked by the other waveform
generator output.
Not all waveform shapes can be frequency tracked. When :WGEN<w>:TRACk or
:WGEN<w>:TRACk:FREQuency is enabled, the other generator's waveform
selections (:WGEN<w>:FUNCtion) must be in the same group as this generator's
waveform:
When tracking is enabled, adjustments for tracked settings in the other waveform
generator become unavailable.
Query Syntax
:WGEN<w>:TRACk:FREQuency?
The :WGEN<w>:TRACk:FREQuency? query returns whether frequency tracking is
on or off.
Return Format
<on_off><NL>
<on_off> ::= {1 | 0}
See Also • ":WGEN<w>:TRACk:PHASe" on page 1312
• ":WGEN<w>:FUNCtion" on page 1282
• ":WGEN<w>:TRACk" on page 1308
• ":WGEN<w>:TRACk:AMPLitude" on page 1309
• ":WGEN<w>:TRACk:CSIGnal" on page 1310
Group 1 Group 2 Group 3 Group 4
SINusoid
RAMP
SINC
CARDiac
GAUSsian
SQUare
PULSe
EXPRise
EXPFall
ARBitrary
To Next Page
Loading...
