:POWer Commands 26
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 697
:POWer:SIGNals:VSTeady:TRANsient
(see page 1428)
Command Syntax
:POWer:SIGNals:VSTeady:TRANsient <value>[suffix]
<value> ::= Expected steady state output Voltage value in NR3 format
[suffix] ::= {V | mV}
The :POWer:SIGNals:VSTeady:TRANsient command specifies the expected steady
state output DC voltage of the power supply for transient response analysis.
This value is used along with the overshoot percentage to specify the settling band
for the transient response and to adjust the vertical scale of the oscilloscope.
Query Syntax
:POWer:SIGNals:VSTeady:TRANsient?
The :POWer:SIGNals:VSTeady:TRANsient query returns the expected steady state
voltage setting.
Return Format
<value><NL>
<value> ::= Expected steady state output Voltage value in NR3 format
See Also • ":POWer:TRANsient:APPLy" on page 708
• ":POWer:SIGNals:AUTosetup" on page 681
• ":POWer:SIGNals:DURation:TRANsient" on page 689
• ":POWer:SIGNals:IEXPected" on page 690
• ":POWer:SIGNals:OVERshoot" on page 691
• ":POWer:SIGNals:SOURce:CURRent<i>" on page 698
• ":POWer:SIGNals:SOURce:VOLTage<i>" on page 699
To Next Page
Loading...
