Keysight Technologies InfiniiVision MSO-X 4022A

1104 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
31 :SYSTem Commands
Introduction to
:SYSTem
Commands
SYSTem subsystem commands enable writing messages to the display, setting
and reading both the time and the date, querying for errors, and saving and
recalling setups.
:SYSTem:RLOGger:DESTi
nation <dest> (see
page 1114)
:SYSTem:RLOGger:DESTi
nation? (see
page 1114)
<dest> ::= {FILE | SCReen | BOTH}
:SYSTem:RLOGger:DISPl
ay {{0 | OFF} | {1 |
ON}} (see page 1115)
:SYSTem:RLOGger:DISPl
ay? (see page 1115)
<setting> ::= {0 | 1}
:SYSTem:RLOGger:FNAMe
<file_name> (see
page 1116)
:SYSTem:RLOGger:FNAMe
? (see page 1116)
<file_name> ::= quoted ASCII
string
:SYSTem:RLOGger:STATe
{{0 | OFF} | {1 |
ON}} (see page 1117)
:SYSTem:RLOGger:STATe
? (see page 1117)
<setting> ::= {0 | 1}
:SYSTem:RLOGger:TRANs
parent {{0 | OFF} |
{1 | ON}} (see
page 1118)
:SYSTem:RLOGger:TRANs
parent? (see
page 1118)
<setting> ::= {0 | 1}
:SYSTem:RLOGger:WMODe
<write_mode> (see
page 1119)
:SYSTem:RLOGger:WMODe
? (see page 1119)
<write_mode> ::= {CREate |
APPend}
:SYSTem:SETup
<setup_data> (see
page 1120)
:SYSTem:SETup? (see
page 1120)
<setup_data> ::= data in IEEE
488.2 # format.
:SYSTem:TIME <time>
(see page 1122)
:SYSTem:TIME? (see
page 1122)
<time> ::= hours,minutes,seconds
in NR1 format
:SYSTem:TOUCh {{1 |
ON} | {0 | OFF}} (see
page 1123)
:SYSTem:TOUCh? (see
page 1123)
{1 | 0}
Table 142 :SYSTem Commands Summary (continued)
Command Query Options and Query Returns