264 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
7 Root (:) Commands
:AUToscale:CHANnels
(see page 1610)
Command Syntax
:AUToscale:CHANnels <value>
<value> ::= {ALL | DISPlayed}
The :AUToscale:CHANnels command specifies which channels will be displayed on
subsequent :AUToscales.
• When ALL is selected, all channels that meet the requirements of :AUToscale
will be displayed.
• When DISPlayed is selected, only the channels that are turned on are
autoscaled.
Use the :VIEW or :BLANk root commands to turn channels on or off.
Query Syntax
:AUToscale:CHANnels?
The :AUToscale:CHANnels? query returns the autoscale channels setting.
Return Format
<value><NL>
<value> ::= {ALL | DISP}
See Also • "Introduction to Root (:) Commands" on page 258
• ":AUToscale" on page 261
• ":AUToscale:AMODE" on page 263
• ":VIEW" on page 297
• ":BLANk" on page 266
To Next Page
Loading...
Need help?
General
