Keysight Technologies InfiniiVision MSO-X 4022A

50 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
1 What's New
Changed
Commands
:SEARch:SERial:CAN:SYMBolic:
SIGNal (see page 1038)
Specifies signal to search for when CAN symbolic data has been
loaded (recalled) into the oscilloscope and the CAN serial search
mode is set to MSIGnal.
:SEARch:SERial:CAN:SYMBolic:
VALue (see page 1039)
Specifies signal value to search for when CAN symbolic data has
been loaded (recalled) into the oscilloscope and the CAN serial
search mode is set to MSIGnal.
Command Description
Command Differences
:SBUS<n>:CAN:TRIGger (see
page 794)
You can now trigger on symbolic messages (with parameter
MESSage) or messages and signal values (with parameter
MSIGnal).
:SBUS<n>:LIN:TRIGger (see
page 881)
You can now trigger on parity errors (with parameter PARityerror)
or checksum errors (with parameter CSUMerror).
:SEARch:SERial:CAN:MODE
(see page 1031)
You can now search for symbolic messages (with parameter
MESSage) or messages and signal values (with parameter
MSIGnal).