Keysight N1911A

To Next Page

To Previous Page

MEASurement Commands 2

N1911A/1912A P-Series Power Meters Programming Guide 113

Resolution

The <resolution> parameter sets the resolution of the specified window. This

parameter does not affect the resolution of the remote data but it does affect the

auto averaging setting. Where a channel is set up in both the upper and lower

window and the <resolution> parameter settings for these windows are

different, the highest resolution setting is taken to calculate the averaging. If you

are making a ratio or difference measurement the <resolution> parameters are

applied to both channels.

Source List

The <source list> parameter is used to define:

– What channels the measurements will be made on, for a dual channel

measurement.

– Whether the calculation is A-B or B-A, for a dual channel difference

measurement.

– Whether the calculation is A/B or B/A, for a ratio measurement.

Entering a <source list> is only required if you are using an N1912A. As the

N1911A has a single channel only, the source list can only be Channel A.

The following commands are described in this chapter:

Keyword Parameter Form Notes Page

CONFigure[1]|2|3|4? [query only] page 116

CONFigure[1]|2|3|4

[:SCALar]

[:POWer:AC] [<expected_value>