SYSTem Subsystem 12
N1911A/1912A P-Series Power Meters Programming Guide 499
SYSTem:COMMunicate:LAN:CURRent:DGATeway?
This command returns the current setting of the LAN IP router/gateway address in
use by the power meter.
Syntax
Example
If DHCP or AutoIP are enabled and successful, then one of these IP address
modes assigns the LAN IP router/gateway address, otherwise it is the static LAN
IP router/gateway address
SYST:COMM:LAN:CURR:DGAT? This command queries the current setting of
the LAN IP router/gateway address.
To Next Page
Loading...
