10 SENSe Subsystem
364 N1911A/1912A P-Series Power Meters Programming Guide
[SENSe[1]]|SENSe2:FREQuency[:CW|:FIXed] <numeric_value> 416
[SENSe[1]]|SENSe2:FREQuency[:CW|:FIXed]:STARt <numeric_value> 418
[SENSe[1]]|SENSe2:FREQuency[:CW|:FIXEd]:STEP <numeric_value> 421
[SENSe[1]]|SENSe2:FREQuency[:CW|:FIXed]:STOP <numeric_value> 424
[SENSe[1]]|SENSe2:MRATe <character_data> 427
[SENSe[1]]|SENSe2:POWer:AC:RANGe <numeric_value> 430
[SENSe[1]]|SENSe2:POWer:AC:RANGe:AUTO <boolean> 432
[SENSe[1]]|SENSe2:SWEep[1]|2|3|4 Commands 434
[SENSe[1]]|SENSe2:SWEep[1]|2|3|4:AUTO <character_data> 435
[SENSe[1]]|SENSe2:SWEep[1]|2|3|4:AUTO:REF1|REF2 <numeric_value> 437
[SENSe[1]]|SENSe2:SWEep[1]|2|3|4:MARKer[1]|2:POWer? 439
[SENSe[1]]|SENSe2:SWEep[1]|2|3|4:OFFSet:TIME <numeric_value> 440
[SENSe[1]]|SENSe2:SWEep[1]|2|3|4:TIME <numeric_value> 442
[SENSe[1]]|SENSe2:TEMPerature? 444
[SENSe[1]]|SENSe2:TRACe Commands 445
[SENSe[1]]|SENSe2:TRACe:UNIT <character_data> 446
[SENSe[1]]|SENSe2:V2P ATYPe|DTYPe 448
SENSe[1]|SENSe2:TRACe:OFFSet:TIME <numeric_value> 450
SENSe[1]|SENSe2:TRACe:TIME <numeric_value> 452
SENSe[1]|2:TRACe:AUToscale 454
SENSe[1]|2:TRACe:LIMit:LOWer <numeric_value> 456
SENSe[1]|2:TRACe:LIMit:UPPer <numeric_value> 458
SENSe[1]|2:TRACe:X:SCALe:PDIV <numeric_value> 460
SENSe[1]|2:TRACe:Y:SCALe:PDIV <numeric_value> 462
This chapter explains how the SENSe command subsystem directly affects device
specific settings used to make measurements.
To Next Page
Loading...
