SENSe Subsystem 10
N1911A/1912A P-Series Power Meters Programming Guide 445
[SENSe[1]]|SENSe2:TRACe Commands
These commands are used to set:
– The upper and lower limits for the trace display
– The delay between the delayed trigger point and the start of the trace
– The duration of the trace
– The trace units.
The following commands are detailed in this section:
SENSe[1]|2:TRACe:LIMit:LOWer <numeric_value>
SENSe[1]|2:TRACe:LIMit:UPPer <numeric_value>
SENSe[1]|SENSe2:TRACe:OFFSet:TIME <numeric_value>
SENSe[1]|SENSe2:TRACe:TIME <numeric_value>
[SENSe[1]]|SENSe2:TRACe:UNIT <character_data>
These commands can only be used with P-Series and E9320 sensors. The E9320
sensor must be set to NORMal mode.
To Next Page
Loading...
