Power Meter Remote Operation 1
N1911A/1912A P-Series Power Meters Programming Guide 59
Figure 1-3 Averaging Range Hysteresis
Filter Length
You specify the filter length using the following command:
[SENSe[1]]|SENSe2:AVERage:COUNt <numeric_value>
The range of values for the filter length is 1 to 1024. Specifying this command
disables automatic filter length selection. Increasing the value of the filter length
reduces measurement noise. However, the time to take the measurement is
increased.
Minimum Sensor Power Minimum Sensor Power + 10 dB
Range Hysteresis
10.5 dB9.5 dB
To Next Page
Loading...
