14 TRIGger Subsystem
670 N1911A/1912A P-Series Power Meters Programming Guide
TRIGger[:SEQuence]:SLOPe <character_data>
This command specifies whether a trigger event is recognized on the rising or
falling edge of a signal.
Syntax
Parameters
This command is also applicable for external triggered average measurement
when used with 8480, N8480, E4410, E9300 or E9320 sensor (Average mode
only).
Item Description/Default Range of Values
character_data How a trigger event is recognized:
– POSitive: a trigger event is recognized on the rising edge of a
signal.
– NEGative: a trigger event is recognized on the falling edge of a
signal.
POSitive
NEGative
:SLOP
Space
?
character_data
TRIG
:SEQ
To Next Page
Loading...
