9 PSTatistic Subsystem
332 N1911A/1912A P-Series Power Meters Programming Guide
PSTatistic:CCDF:REFerence[:STATe] <boolean>
This command is used to turn on or off the reference trace and it is independent of
the channel attached.
Syntax
Example
Reset Condition
On reset, the reference trace will be cleared.
This command is only applicable when P-Series sensors are present and the
following conditions are met:
– Free-run acquisition mode is selected
– NORMal or DOUBle measurement speed setting is chosen
– Expanded window is enabled (not full CCDF screen window)
0|OFF
1|ON
Space
:STAT
PST
:CCDF :REF
?
PST:CCDF:REF ON This command turns on the previously saved
reference trace.
PST:CCDF:REF OFF This command turns off the previously saved
reference trace.
To Next Page
Loading...
